BookDrive DIY Hardware Manual
From Atiz Support Wiki
(Difference between revisions)
Revision as of 05:20, 3 February 2009 Admin (Talk | contribs) ← Previous diff |
Revision as of 05:20, 3 February 2009 Admin (Talk | contribs) Next diff → |
||
Line 1: | Line 1: | ||
- | == | + | == '''Safety Precautions''' == |
- | '''Safety Precautions''' == | + | |
Assemble everything on the floor first. Once the assembly is complete, carry the whole machine with at least 2 persons from the floor to the table. | Assemble everything on the floor first. Once the assembly is complete, carry the whole machine with at least 2 persons from the floor to the table. | ||
Line 9: | Line 8: | ||
- | == | + | == '''Getting to know your BookDrive DIY''' == |
- | '''Getting to know your BookDrive DIY''' == | + | |
''' | ''' | ||
BookDrive DIY has the following components.''' | BookDrive DIY has the following components.''' | ||
Line 17: | Line 15: | ||
- | == | + | == '''How to assemble the platform''' == |
- | '''How to assemble the platform''' == | + | |
'''Step 1''' Place the base on the table and connect the left and right legs to the base as shown. | '''Step 1''' Place the base on the table and connect the left and right legs to the base as shown. | ||
Revision as of 05:20, 3 February 2009
Safety Precautions
Assemble everything on the floor first. Once the assembly is complete, carry the whole machine with at least 2 persons from the floor to the table.
- Place the machine on a level surface to ensure proper working condition. Do not tilt the machine.
- Do not place the machine near heaters or volatile, flammable or combustible materials that may catch fire.
- BookDrive DIY is not designed to be lifted. Do not lift or relocate the machine once it has been fully assembled. To relocate the machine, de-assemble it into parts first and then re-assemble them again at the desired location.
Getting to know your BookDrive DIY
BookDrive DIY has the following components.
How to assemble the platform
Step 1 Place the base on the table and connect the left and right legs to the base as shown.
Step 2 Tighten 3 knobs on the front, 3 knobs on the rear and 2 knobs on the inner side of each leg.
Step 3 Connect the arm to the leg. The sticker on the end of the arm should match with the sticker on the end of the leg. Then tighten the knobs. Repeat on the other side.
Step 4 Fix the V glass with the arm connector. Tighten 2 knobs with nuts at each left and right side.